Orchid Propagation - seed or root method?
How does it work to stem the spread? Many orchids Winzer this question. All procedures are complex and a beginner is better than an audience to the expert. The task is so complex that the person, the procedure must be treated as a medical operations. Orchids are delicate plants, must have all the tools and the new vessel is sterile, so it is treated as a medical procedure.
The orchids are propagated by stem cells raise or seedlings. MultiplicationTypes means that there are different types of procedures to follow. Some species can be divided to grow more crops, while others from sowing to play.
Hybrid nature was perfected, have been developed from the expansion of stem cells, since this is the simplest and most practical, since not all growers of orchids in a wide knowledge of genetics that allows them to build a laboratory for would conduct experiments. Finally, it was the breeder who has developed thisMethod.
Below is an example of a procedure, followed by orchids spread.
But first you need the right tools and equipment for the job.
As for the tools:
1, a rectangular plastic tray, the sterilized
2, 1 spray bottle
3, square bottle, which is where you make the cuts.
4, sterilized razor blades
5, tweezers
6, culture tubes
7, U-BahnRack
8, old, soft toothbrush
9, Cotton
10, Pressure cooker
Now we are with the chemicals you need:
1, or Clorox bleach (try to stick with household bleach, as this is the safest)
2, detergent
3, agar-agar
4, stem propagation media
5, distilled water
Set up your "laboratory" in a clean sterile. If you can afford to build children's garden complete with lightingand temperature, then they go. These are very important when the plants are available.
Well, since all you need is the time to start:
- First, prepare the medium. There should be a set of instructions that come with it. You have to cook the mixture, then distribute them in culture tubes should be 1.5 inches deep. Get ready for your pressure cooker and cook the culture tubes for about 15 to 20 minutes. This is to sterilize the mixture.
The nextStep, a ratio of 3:01 solution of bleach and water and few drops of dishwashing detergent to prepare. To this solution to the plastic tray and the bottle must be filled. Mix a solution of the 09:01:02 (water, bleach, detergent) and spray the bottle square uninterrupted.
- Hygiene is the key to the whole operation is all your efforts, which are eaten by fungus, when the whole operation is compromised because of lack of sanitation.
- Put the bottles, tubes, cotton and synthetic cuttingInstruments in the mix in case of keeping them clean.
- Select propagate the orchid. Cut with a razor blade, and once again fails sterilized knife or the entire operation.
- Insert the stem into the tray with the bleach solution.
- Brush the stem from bottom to top, do it carefully or you will damage the bud. In addition, the toothbrush should be sterilized.
- Once done, put the bottles in the mix at random.
- Now you can start the spread ofCut the stem an inch above and below each bud. The cut should be made at a certain angle to get rid of the coatings gem. Put in a ball, which should contain a mixture of bleach. Leave for 15 to 20 minutes to take effect. Think you shake the bottle every 5 minutes. Keep them at room temperature.
-Taking stem cells from the containers after 15 or 20 minutes, cut an eighth of an inch at the ends, then the tensions in the culture tubes. Change the position of the pins and tubesa rack on the rise.
- Label the tubes to avoid confusion.
- Provided that the whole procedure went well, you should see the growth after some time.
- Once the leaves are a third of an inch of an inch long, take them out of their tubes and planted in their pots.
No comments:
Post a Comment